RANGE TROUBLESHOOTING
ELECTRONIC RANGE
Fault
Codes click here
Surface elements not working
Make
sure the two 20 fuses are good,check them with a ohm meter.
Check and
make sure there's 240 volts at the plug,check with a volt meter.
Check elements
to if they are burnt out,using a ohm meter.
Check infinite
switch using a volt meter ,check for 240 volts on terms H1-H2,
if no voltage is found replace switch.
Check element
plug-in blocks by removing the elements & block,do a visual
inspection to check for burning on the inside, if burnt replace.
Oven to hot
Defective
oven control.
Bake relay
stuck closed, check with a ohm meter,if defective replace (SELF
CLEAN ONLY).
Self clean not working
Defective
oven control.
Defective
(open relay)(SELF CLEAN ONLY).
Door not
locked or locking(SELF CLEAN ONLY).
Possible
defective door switch.
Clock start
or stop time not set.
Clock/timer not working
Defective
Clock/timer.
Bake element not working
Defective
bake element.
Defective
bake relay (SELF CLEAN ONLY.
Defective
oven control.
Broil element not working
Defective
broil element
Defective
broil relay (SELF CLEAN ONLY).
Defective
oven control
Oven not working
Defective
oven control.
Burnt wires
at main term.block (L-1 & L-2)
Make sure
the two 30 amp oven fuses are good,check with a ohm meter
